diff --git a/cyberia_hq/3d_printer.myco b/cyberia_hq/3d_printer.myco
index 7650f9f..e6afd19 100644
--- a/cyberia_hq/3d_printer.myco
+++ b/cyberia_hq/3d_printer.myco
@@ -12,11 +12,10 @@ A slicer is a program that will take a 3D model and convert it into instructions
-### 3. prepare the printer
-Turn the printer on. It has an automatic bed leveling routine that you must start from the printer's control panel. You should do this every time to avoid ruining the print bed.
-
-### 4. send it to octoprint
+### 3. send it to octoprint
Octoprint is a program running on `printstation` that talks directly to the printer and feeds it instructions while monitoring all of its sensors. The slicers on `printstation` are set up to be able to upload files directly to it. Octoprint is not itself a slicer.
-Ensure Octoprint is connected to the printer in the top left section. If everything looks good you can print the model from the "Files" section below it.
+Turn the printer on, then ensure Octoprint is connected to it in the top left section. If everything looks good you can print the model from the "Files" section below.
+
+The printer has an automatic bed leveling routine that it will run before starting every print which is necessary to prevent bed damage and to keep your print stuck down evenly.
-### 5. finishing up
+### 4. finishing up
When the print is done, pick up the magnetic build plate and flex it to remove your print, //including the excess bits (skirts, rafts, supports, etc.)//. Turn the 3D printer off to save power.